The radial stacker can work simultaneously in different stockyards. This efficient and large bulk material handling equipment is applicable to stacking cement, coal, metallurgical flour and chemical products. The stockyard system can handle a variety of materials, however, it must be noted that only a single material type can be stored in a single tank.

• SINOMALY’s stacker reclaimer is equipped with a boom made using a thick and solid I-beam in order to guarantee the boom strength and increase the bulk material conveyance distance.
• The overall structure of the stockyard should be taken into account during the automatic control design for the stacker reclaimer’s side boom. To be more specific, the stockpile height should be pre-determined to ensure a flexible, efficient material stockpiling and reclaiming throughout the entire stock yard.
• This bulk material handling equipment is outfitted with several control methods, which will ensure flexible bulk material handling in different situations.
• With an easy installation, the side boom stacker can be easily operated by a single employee after a simple training process.

There are three operation modes for the side boom stacker reclaimer: automatic control, on-board manual control and side (maintenance) control. Each operation mode is carried out through an alternation switch.

• Automatic control
  Under automatic control, the stacking operation is carried out in the on board, central control room. When a central control room is required to automatically control the stacker and reclaimer, the operator needs to only press the operation button on the console, then press the start button. All electrical equipment on the stacker will start according to the predetermined procedures, and the stacker reclaimer will automatically operate. On the operation console, operators can start or stop an entire stock yard system simply by pressing a button.
• On-board manual control
  During the debugging process or in the event errors occur during automatic control, the operation in the control room simply needs to use the on-board manual control to carry out stacking operations. When manual control is in use, the equipment cannot switch to automatic or side (maintenance) control.